Benefits:

  • Long-lasting all weather protection for primarily wooden decks
  • UV, water and mould resistant
  • Superior scratch resistance
  • Quick drying suede finish

Product Specs:

Available in 1 and 5-litre packs.

Colours:

  • Clear
  • Tint Base
  • Teak

Technical Data Sheet

CODE:
WDO

DESCRIPTION
Deck Oil is a penetrating type of dressing. Previously varnished surfaces will have to be sanded back to bare wood to allow the material to soak well into the wood. Ideal for exterior wood such as wendy houses, sun decks, window frames, doors, fascia/barge boards etc where a durable, easily maintained waterproof dressing is required.

PRODUCT BENEFITS
Will not crack, flake or disintegrate on timber. Especially formulated using a blend of synthetic resins, oil, water repellent and preservatives which will give deep down protection & UV Resistance. Designed to stain the wood and enhance its natural beauty, highlighting the grain of the wood. Non-toxic. Easy application and used on both soft and hard woods.

SURFACE PREPARATION:
NEW: Surface must be clean, dry and well sanded. A minimum of 3 coats must be applied allowing 6 – 8 hours drying time between coats. Thin first coat up to 25% with mineral turps to ensure sufficient penetration.
PREVIOUSLY VARNISHED: Thoroughly sand and remove all previous coating to allow Deck Oil to penetrate the fibres of the wood.

PREVIOUSLY TREATED WITH DECK OIL: Wipe down with steel wool and mineral turps to remove dirt and grime. Apply 1 – 2 coats of Deck Oil as required.

PRECAUTIONS
Must be well stirred with flat paddle before use. Do not apply to wet/damp timber. Important to treat the end grain of all exposed exterior timber to prevent the ingress of moisture. Important to apply a generous first coat on new timber. Maintenance coats should be applied every 6 – 12 months where necessary.

APPLICATION:
Stir thoroughly with flat paddle before use. Application by brush – allow material to soak well into new timber. Minimum of 3 coats should be applied with light sanding between coats, for maximum protection. Pay attention to the end grain. End grain may need additional coats to prevent moisture ingress. Clean up with Mineral Turps.

TECHNICAL DATA: 
Type: Synthetic resin, oil, water repellent plus preservative
Drying Time: (T) 4 Hours
@ 25oC (H): 48 Hours
Recoat: 6 – 8 Hours
Viscosity: 15 – 20 seconds Ford Cup 4 @ 25°C
Spread Rate: Approx. 8 – 10m2/L depending on density of timber.
Flashpoint: 37°C
Solids Volume: 30 – 35%
SG: 0.87 – 0.89
Solids Mass: 35 – 39%
Finish: Low Sheen
Colour Range: Clear, Imbuia, Teak & Mahogany
Pack Size: 5L

Health and Safety: Refer to Material Safety Data Sheet

Download Technical Data Sheet

Reviews

Be the first to review “Deck Oil”

Contact a Store

Pietermaritzburg, Midlands (Retail)
Morne van Straaten: 076 501 1429
morne@dekadepaints.co.za

North Coast (Retail/Trade)
Prem Gokulpersad: 082 807 9102
premg@dekadepaints.co.za

South Coast (Retail/Trade)
Property Administrators & Specifications
Jill Pinto: 082 499 2172
jill@dekadepaints.co.za

Trade Enquiries
Tracy Robinson: 082 417 9050
manager@dekadepaints.co.za

Case Studies Projects